Chevrolet C/K 1500 Questions Maintenance & Repair
E-brake Light Stays On
the light that indicates my e-brake is on stays on even when there is no pressure on the e-brake and it is fully relaxed. i dont know how long its been like that or if it just started because the ligh...
Head Bolt Torque
I just reinstalled my Vortec heads per specs. The final adjustments were degrees according to the length of the bolt. I understand this is for bolt stretch. But, being old school, is there a final tor...
Right Turn Signal Won't Work When Lights Are On
My chevy 1500 right turn signal won't work when lights are on, when I shut lights off it blinks all four blinker lights. When lights are off and I push brake pedal the parking lights also go on any h...
95 Chevy PU Front End Shakes When Brakes Are Applied, What Would Cause This...
When I apply the brakes the whole front end shakes, when brakes are applied hard it doesn't. Could the roaters be warped?
Speedometer Doesnt Work Sometimes..WHY????
What could be wrong with my speedometer if it only works sometimes? How do you fix it?
FUEL PUMP ISSUE ?
MY 94 CHEVY RUNS GREAT IN ALL CONDITIONS EXEPT WHEN I AM PULLING A LONG HILL. USUALLY ABOUT HALF WAY UP THE HILL ON THE INTERSTATE (RUNNING BETWEEN 55 - 70 MPH) THE ENGINE WILL SORT OF MISS, KINDA OF ...
My Headlights Aren't Working, Yet All The Other Lights Are. Any Ideas?
Don't know if it makes a difference, but the day that I noticed the lights weren't working, I took a turn into my shops driveway, hit a bump, and heard a metallic thunk in the front driverside wheelwe...
Replace Headlight Bulbs
I can't see how to get at the headlight bulbs to replace one that is burned out. Surely you don't have to remove the grill to do this? Thanks, TR
Remove Truck Door Panel
I have to open the driver side door by rolling down the window and opening it from the outside. How do I remove the door panel to fix the door handle on the inside?
My Tail Lights Went Out. I Have Changed The Fuse And Also The Brake Relay F...
I have also checked the bulbs and they are all fine. Couldnt find any damaged wiring as well.
The Bed, And It Seems The Entire Right Side Of The Vehicle Sits A Bit Highe...
No collision or frame damage. The truck is a 8 foot bed work truck model, runs great.
Pinion Seal
well i plan on changing the pinion seal on my truck(10 bolt)....I was told to make sure and not over tighten the nut that goes into the crush sleeve....The question im asking is about how tight should...
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.