GMC Envoy Questions Maintenance & Repair
I Have A 2007 GMC Envoy Denali 5.3 It Ranks Wont Start
2007 envoy denali 5.3 starts and cuts off with in 45 mins or so and won't start back up but cranks, fuel pressure is at 60 lb the fuel relay gets hot while its running and cuts off could it be a bad...
How To Start After Running Out Of Gas And Putting Singe Gas Into Gas Tank
Ran out of gas and put about 2 gal into gas tank. How do I start the vehicle?
My Gmc Envoy 05 Running Rough
I have been dealing with my gmc envoy for a while I changed the belt , all 6 ignition coils along with spark plugs , oil change , brakes done as well , along with the position sensor . So my questi...
Trans And Misfire 03 Envoy Trailblazer
I have a 03 envoy came in trans was "slipping" and misfiring runing horrible. Replaced trans and still doing exact same thing you have to hold it to the boards to even get the tire to spin seems to...
Ignition Coil Wires
I accidentally touched the ignition coil wires together while the engine was running. It shut the engine off and now all the dash lights come on when I turn the key on but it won't start.
Ac
Air conditioner is blowing hot I want cool ????
Car Problems
I just changed my throttle body because i thought it was the problem. But my car wont accelerate past like 12 miles an hour.
Transmission
What transmission oil do I put in my 2005 GMC envoy 4wd
#2 Cylinder Misfire
Took to auto zone ran diagnostics code po420 how do I determine which of multiple reasons for misfire they include; 1. Leakage into exhaust valve guide seals spark plugs or wires. 3. Coils
Fuel Pump Relay
How do I check the fuel pump relay?
DMV Inspection
I have a p1481 code come up what does that mean
Vehicle Won't Start
My truck has a fuel leak. I parked it, everything worked. When I came back to it, I had to recharge the battery. Battery is fully charged but now it won't start. There are no clicking noises, light...
Engine Shut Off Without Warning Problem Of The 2003 Gmc Envoy
My car will shut off when I am either turning or slowing down without any warning, I put the car in neutral, turn the key off then on again and it starts like nothing happened. The engine doesn't ...
My Headlights
So I realized that i have no low beams in our 2008 gmc envoy. We have checked the bulbs i have checked the fuses and everything seems ok but no lights the only option I have is high beam?? So lost...
Inspection Code
Code p0340 cam shaft position sensor A circuit bank 1 came up after I changed cam shaft position sensor
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.