Chevrolet C/K 10 Questions Maintenance & Repair
72 Chevy Pick Up
Truck shut down when driving
Oil Pump
How to install a oil pump
Starter Bolts.
Starter bolts won't tighten up.
1980 Chevy K10
I bought this truck about a year ago and got it up and running it has a 350 in it with a 4 barrel carb on it. It was running really good until about a month ago I started to notice a small hesitate...
Truck Won't Start
Engine will turn over but wont spark brand new distribututor all new spark plugs and new fuel pump also a new starter... when I turn it over it spits fuel out of the carb but I can't get a spark w...
Chevy C-10 Melted Power Cable After Replacing No Power To The Switch ?
My c-10 won't start ! I put a new flex plate in and must of moved the positive battery cable it melted against the exhaust manifold ... I replaced the cable now turn signals work in run position bu...
Gas Cut Off
I have a 79 Chevy c10 pick up truck with a 88 Chevy c1500 pick up truck engine, I changed the fuel pump and check the filters but it still cuts off when I hit the gas pedal. Like if I'm doing 30 I'...
Running Lites Not Working
All other lites work, but not the running lights. I've checked fuses, OK. Don't know the trim. It's standard cab, absolutely no extras. Two wheel drive, automatic
Black Box On Outer Firewall With Prons
on the right side of my outer firewall has two small plastic boxes one white and one black with prons going different directions, I held down my key to light testing my starter, and it started smok...
Brake Light 85 C10
Replaced turn signal switch less than a year ago when both lights stopped working in the rear. Now I have both tail lights but no left turn signal or left hazard light.
Why Is My 62' C10 Dying After 5 Minutes Of Driving?
1962 Chevy C10. [350 small block with msd drop in vacuum advance distributor and a Carter 600-No Choke. 3 on the tree with overdrive.] New keyed Ignition cylinder, new upgraded fuse box, clean set ...
82 Chevy K10 Motor Or Transmission
I have a 82 Chevy k10 with 350 and 350 turbo 4 speed auto. It will cruze down the road fine but when you stomp down on it it hesitates real bad. But it only does it in gear runs fine reving it up. ...
I Did A Flex Plate On 1985 K10 And Now It Wont Move
I have double checked everything everything is hooked up ,has fluid and all the bolts are in. I'm at a lose with it dont know what else it may be any help would be grat
Transmission Fluid
Can anyone tell me off the the top of their head what transmission fluid I would be using for 700R4 on my '83 Chevy Silverado 6.2L Diesel 2WD?
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.