turn signals don't work

Did you install the correct bulbs? This is strange because the hazards and the turn signals as well as the brake lights all use the same wire. There is a separate flasher for the turn signal it could be that. Try this find one flasher turn the hazards on to see if it's the hazard or turn signal, then find the other around the steering column the one not flashing will be the turn flasher, I hope this helps

My wiring diagram for your model year isn't the best, it showed a turn fuse and a different hazard fuse. Turn fuse, fuse 5--15 amp in fuse box, check the fuse. Just a thought.

fuse is good and I put correct bulbs. I have all lights except turn signals. I just had the whole column opened up putting the new turn signal switch. the flasher fuse is also brand new. I'll habe to see if I can find a second flasher fuse but I haven't seen one so far

Did you check for voltage at turn fuse? Use a test light to check for voltage, should go hot with the key on.

I'll check that when I get off work tomorrow

Did you find 2 flashers?

I only found one flasher

Turn on the hazards and feel that flasher is it's clicking look for the other one. The dealer or some pars stores have component locators that I'm sure will direct you to one of the column braces although I've seen them hidden behind the glove box so you never know. Let me know how you turn out, questions on this site show up on My email

I don't seem to be getting power to my flasher for my turn signals. I pulled flasher off and hooked it to hazard and the flasher fuse worked so now I gota figure out why there's no power to turn signal flasher in fuse box

there's gota be a short somewhere. I put a new fuse in my turn signal spot and as soon as I touched hazards it started burning the fuse apart

I turn truck off put in another fuse. as soon as I turned on power. it blew fuse to the turn signal. so now to trace grounds and wires

Does it blow the fuse if the hazards and turn signals are off? If no leave the hazards off and move the sig switch one way then the other, does it blow the fuse on one side and not the other? If yes check that side it's usually in the rear. If the fuse blows with everything off look at where the wiring harness goes into the column they like to rub through there, if not unplug the column harness if the ground goes away the problem is in the column.

the column is all new I just installed it 3 days ago. and it blurs with everything off. all I gota do to blow fuse to turn ignition on it blows instantly

Disconnect the column harness,

Look at the column mounts to see if you have a pinched wire.

I bought new fuses and unplugged and replied up column wires and now no problems. I had some old fuses before. but now it all works fine