have power no spark 1996 s10 blazer have replaced everthing

where does the 12 volts stop in the ignition????

also what sensors?Crankshaft Position Sensor ?

have replaced both sensors. we have 12 volts to everything

u might need to reset the pcm means disconnecting the battery...and cam sensor bad..

We have reset the pcm also we replaced the cam senor with a new one 3 times

do you know how to check the ciol/rotor..pin hole burned thru the rotor??? what engine is it??? did you figure it out ??? put yet another coil on it???

We have replaced the coil twice and the ignition module twice. still don,t known whats is wrong . still, don't have any spark. 4.3L

still domt know what engine it is...check grounds around thermostate..new rotor burned thru?check the White wire and Orange wire to the ignition module, both should have a 0-5 volt square wave sent to them by the Powertrain Control Module (PCM) to tell it when to fire the coils Read more: http://www.justanswer.com/chevy/3bhma-engine-will-not-start- 1996-chevy-s10-2-2-liter-no-spark.html#ixzz3jCbCvEli

4.3L chevy. we now replaced the computer still; no fire