remote starter
When trying to start my trtuck with remote starter the truck starts and then shuts off
within seconds. The message says remote disabled system failure and the mil light stays
on
Malfunction Indicator Light...we must figure out which component is malfunctioning...use a small 14 dollar scanner~ read the trouble codes....then RESET the CODES to make the light go away~
chances are this will not fix your problem but untill you can find a scanner, for smiles and giggles try to disconnect battery wait 20 minutes hook it back up and try it again. as i said it will probably not fix it but worth a shot.
when you hook up the battery start it by key, run it for about 5 minutes and then shut id down wait 5 minutes and try your remote start
does it say remote start disabled or aborted
Mine is doing the same thing. My oil pressure is bad. Could that be the issue. It’s stuck reading 3/4 ways full.
It could be that your fuel level is low. It’s designed to shut off. Make sure at least a quarter tank is available.
My fuel is 3/4 and it turns on then shuts off after a few seconds saying remote start disabled - System fault
