I have a ford bantam 2002 i cant seem to get my braks fuction right every time i bleed them thay just go back to no brakes and while driving i have to pump them to be able to break for a few seconds
11 Answers
Its sucking air somewhere, clean all the pipes and cylinders and check were it leaks.
firebird338 answered 9 years ago
Did you bleed the master cylinder before installing on vehicle ?
firebird338 answered 9 years ago
Was you having this problem of no brakes before or after installing master cylinder and brake pads ?
Yes but caant seem to get the working its as if the system cant hold presure and there is no fluied leaks
firebird338 answered 9 years ago
Did you have any brake work done? Replace calipers, brake pads etc .
firebird338 answered 9 years ago
You have what did a front and rear brake job and what's on the rear shoes or pads ?
Hi, I have similar issue, only mine started after replacing the master cylinder, brake pads was replaced in February 2016, Master cylinder was replaced in June 2016